Bulldog Security RS79P Guia de Instalação descarregar pdf

System Features ....................................... 1

System Components ..................................... 1

Technical Assistance .................................. 1

Before You Begin ...................................... 1

Precautions......................................... 1-2

Making Wiring Connections............................ 2-3

Locating & Making Connections........................ 3-4

Locating & Determining Your Door Lock Types ............ 5

Testing Door Locks .................................... 5

Connecting Door Locks ............................... 5-6

14-Pin Harness Diagram ................................ 6

Door Lock Type by Manufacturer......................... 6

Operating Instructions ................................ 6

Programming Instructions .............................. 7

CONTENTS

KEYLESS ENTRY • MODELS KE100 / KE150 / 1702

INSTALLATION GUIDE

•

OWNER’S GUIDE

Technical Assistance

All tech personnel are expertly qualified to answer any technical questions.

Technicians are available Monday through Friday from 9:00 a.m. until 8:00 p.m. and Saturday 10:00 a.m. until 4:00 p.m.

Address

288 Canton Avenue • Wintersville, Ohio 43953

Telephone

Phone: 740-264-4710 • 800-878-8007 • Fax: 740-264-7306

1 2 3 4 5 6 7 8

Resumo do Conteúdo

Página 1 - OWNER’S GUIDE

System Features ... 1System Components ... 1Technical Assistance ...

Página 2 - PRECAUTIONS

SYSTEM FEATURESFour-Button Remote Control Remotely lock and unlock your car from a distance.Starter Immobilizer You can’t steal what you can’t start.

Página 3 - MAKING WIRING CONNECTIONS

DO NOT leave the interior or exterior lights on for an extended period of time as it may cause batterydrain.DO NOT mount the control module until all

Página 4 - Wire Tie

4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection.Secure with wire ties as shown.3. Lay upper twisted pair

Página 5 - (-) from

Note: Remove any paint belowthe spade connector.Factory BoltSpade ConnectorBlack Ground WireSTARTER IMMOBILIZER (-) (Optional relay Part #773 require

Página 6 - CONNECTING DOOR LOCKS

There are 3 basic system types:“Type A” Door Lock Test (Most GMs and most Chryslers)Probe both of your door lock wires going to the door lock switch t

Página 7 - OPERATING INSTRUCTIONS

NOTE: You will need to cut factory wiring tomake an end to end connection, see “MakingConnections” on page 3.“Type C” Reverse PolarityNOTE: Connect th

Página 8 - PROGRAMMING INSTRUCTIONS

PROGRAMMING INSTRUCTIONSTo enter programming modePress button #4 for 10 seconds then release. You are now in programmingmode. To exit programming mode