Bulldog Security 721 Guia de Instalação

CONTENTSREMOTE STARTERMODELS DELUXE 12 and DELUXE 22INSTALLATION GUIDE•OWNER’S GUIDETechnical AssistanceAll tech personnel are expertly qualified to a

9“Type C” Reverse Polarity (5-pin harness)NOTE: You will need to cut factory wiring to make an end toend connection, see “Making Connections” on page

10OPERATOR PROGRAMMING INSTRUCTIONSProgramming Door Lock Pulse Length 3.5 (from .7 to 3.5 seconds)Press and hold the brake, then press and hold Button

HOW TO USE YOUR REMOTE TRANSMITTERStarting the Vehicle with the Remote TransmitterPress and release button #1 (start). The parking lightswill flash on

SYSTEM FEATURESSYSTEM COMPONENTSTECHNICAL ASSISTANCEShould you need help. First check our website at www.bulldogsecurity.com/wires.htm or call our tol

BEFORE YOU BEGINMAKING WIRING CONNECTIONS1. Strip back two inches of insulation on the wire from the keyless entry.2. Strip back one inch of insulatio

4. Insert the wire from the unit through the hole as shown.6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side o

ACCESSORY WIRE(S) THAT POWER THE HEATER/BLOWER MOTOR(+12V in run or on positions) This wire is also in the main ignition switch harness usually locate

5Note: Remove any paint belowthe spade connector.Factory BoltSpade ConnectorBlack Ground WireBRAKE INPUTThe brake wire is located on the switch near a

6MECHANICAL NEUTRAL SAFETY SWITCH (Rear Wheel Drive Only)When installing a Bulldog remote starter on GM vehicles or Dodge Dakotas built prior to 1996,

7CONNECTING THE 18-PIN HARNESS & 4-RELAY HARNESSANTENNA PLACEMENTControl ModuleAntenna WireAntenna TubeFACTORY ANTI-THEFT SYSTEMSFOR GENERAL MOTOR

TESTING DOOR LOCKSTESTING: Door LocksThere are three basic types:“Type A” Door Lock Test (Most GMs and some Chryslers)Probe both of your door lock wir